25 mm conical coupling to drive diesel pumps on any test bench. Length 100, teeth 12 mm
The puller 9463 is recommended to unplug the shaft.

Bracket for assembly / disassembly of common rail pumps, on the workbench.

The circular support must be installed on revolving bases (ref. 8132 or 9260).
The system consists of a circular ring support, on which the (removable) bracket with adjustable projection is mounted, which allows to press the tappets. The circular holder holds an interchangeable round flange, which can rotate 360 degrees and can be locked in any position.
The internal flange allows to fix CP1, CP3, CP4, HP1, HP3, HP4, Delphi and VDO pumps.
Similar to 0 986 612 794

As an additional option, the following optional flanges are also available:
- 8131, for CP3.4 pumps
- 9402, for mechanical pumps A, M, VE, DPC

Torx bit
Similar to 0 986 613 145

10 mm Oldham coupling to drive diesel pumps on any test bench.

9 mm Oldham drive coupling for CP3 (FIAT) ans Siemens pumps on any test bench.
Similar to 1 685 702 090

Flexible High pressure line L=600 mm. - M12x1,5 - M12x1,5

Flexible pipe ( cr 2500BAR) to connect the high pressure delivery from the pump outlet to the rail. Nuts 14x15 / 14x1,5. Similar to 1 680 712 227

Inserter bracket and oil seal for CP1 and CP3 pumps

Interchangeable mounting plate for CP3 pumps, to be used in conjuction with the operating flange 8130.

This device allows to monitor the pump body pressure (5 BAR).
It is also equipped with ball valve, to measure the negative pressure generated by the pump.
Caution: Not all test benches are able to supply the amount of flow required by the comon rail pumps. Therefore, it is crucial to monitor that, during the test, the pump does not go into cavitation.

Puller with conical thread to extract the radial shaft sealing ring on 25 mm cones.

Tool for the expulsion of the pump sprocket on BMW 520 TDS, 320D.
Similar to 0 986 613 170

Splined coupling to drive CP3.4 (MAN) pumps on any test bench.
Similar to 1 685 702 092